This bug fixing program solves problems with FV31S-SW Viewer and FV31S-DT ver. 2.6.1.
Impacted Products
- FV31S-SW Viewer ver. 2.6.1
- FV31S-DT ver. 2.6.1.
If you use versions of this software other than version 2.6.1, install this modification program after updating it to ver. 2.6.1. FV31S-SW Viewer and FV31S-DT ver. 2.6.1 can be downloaded here.
Problems Solved
- The layout created / saved by ver. 2.6.1 may not be reproduced properly.
- The value of the scale bar set on the Z cross-section image displayed in three sides mode may be incorrect.
Installation Procedure
- Before installing this program, check whether your software is version 2.6.1. If you are using a previous version, please update the software to ver. 2.6.1. FV31S-SW Viewer and FV31S-DT ver. 2.6.1 is available for download here.
- Download this bug fixing software by selecting the Download button on the right side of this page:
Download file name: “patch_2.6.1.243_2.zip” (62.1 MB)
Serial No.: Serial number is inscribed on the software dongle key.
- Install the software:
1) Close all application software.
2) Save “patch_2.6.1.243_1.zip” to your PC’s hard drive and unzip it.
3) Run “patch_all.cmd” as an administrator.
4) After the installation is finished, and no error messages have appeared, press any key to exit.
*If you see the message “ERROR! FV31S-SW 2.6.1.243 not found!”, this means you are not running software version 2.6.1.
Please install this bug fixing software after updating the software to ver. 2.6.1.
You can download ver. 2.6.1 of the software here.
5) FV31S-SW software will automatically start in DT mode to load the changes. Please exit the software when the software startup is complete.
